Black Box IC108A Installationsanleitung PDF herunterladen (Seite 13)

Hardware Installation Guide

revision 1 — 155

• LNL-ETHLAN-MICR with firmware version 5.4 If Micro-100 unit's power is cycled,the unit will

not restore communications unless the reset button on the Micro is pressed.

• LNL-ETHLAN-MICR with firmware version 5.5 If Micro-100 unit's power is cycled, the unit will

fail to restore communications 1/20 times.

In all cases, Lantronix and our Quality Assurance Group have confirmed that removal of Pin 10 will

eliminate all communication failures due to power cycling. Setup and unit configuration remain the same as

as documented.

30.4.5 Removal of Reset Pin

Use the following procedure to remove Pin 10 from the Micro 100 product.

1. Using an ESD grounding strap, ground yourself and remove the Micro 100 from the anti-static bag or

the housing.

2. Locate Pin 10 of Conn1 on the back side of the Micro 100 unit.

3. Protect your eyes with safety goggles. Using shearcutters, cut Pin 10.

4. Replace the Micro 100 into the anti-static bag, or to the equipment that houses the Micro 100.

30.5 CoBox Token Ring Serial Server (LNL-COBOX-201TR)

(A STRAIGHT THROUGH CABLE IS REQUIRED)

Note: This method of communication NOT evaluated by UL for Lenel OnGuard UL1076 product

listing.

Network Requirements:

Token Ring hub

Machine Requirements:

A PC is needed to configure the CoBox Token Ring Serial Server. The machine must have the following

installed:

• Token Ring Network Interface Card (NIC)

• OnGuard Software

• HyperTerminal Software

To Configure the CoBox Token Ring Serial Server (part # LNL-COBOX-TR201):

Step 1: Establish Serial Communication with CoBox

1. With the power OFF to the CoBox device and the network disconnected, establish a serial connection

from the CoBox to the PC’s Serial Communication Port, for example, using HyperTerminal. (A straight

through cable is required).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 34 35

Keine Kommentare

Black Box IC108A Installationsanleitung Seite 13