Black Box Code SW590A-R2 Bedienungsanleitung PDF herunterladen (Seite 20)

CODE OPERATED SWITCH II

After you have hit a key, the screen will change to:

Serial Port Test

The Serial Port Test is a loopback test that checks

whether data is being correctly transmitted and

received on any port. The test also checks, using

DTR/CTS/RI or RTS/DCD, whether the box can

loop back control leads correctly. To use this test,

you will need to jumper Pins 2 and 3. To test

DTR/CTS/RI and RTS/DCD, you’ll need to

jumper Pins 20, 5, and 22 together, and jumper Pins

4 and 8 together.

Interrupt Test

The Interrupt Test checks the interrupt circuitry of

the unit. During this test, the letter “A” will appear

on screen. A message will indicate whether the test

was successful.

All Tests

If you request All Tests, the COS-II will run all the

listed tests in sequence.

INTERRUPT TEST IN PROGRESS

INTERRUPT TEST PASSED

SERIAL PORT TEST (EXPANSION BOARD IS NOT INSTALLED)

PORT# DATA DTR/CTS/RI RTS/DCD

MASTER * FAILED FAILED

PORT 0 FAILED FAILED FAILED

PORT 1 FAILED FAILED FAILED

PORT 2 FAILED FAILED FAILED

PORT 3 FAILED FAILED FAILED

SERIAL PORT TEST FAILED

1 2 ... 15 16 17 18 19 20 21 22 23

Keine Kommentare

Black Box Code SW590A-R2 Bedienungsanleitung Seite 20