Black Box MDS920C-10BT Spezifikationen PDF herunterladen (Seite 5)

of the CO unit should be changed. This feature gives ISPs, LECs and

PTTs the ability to provision bandwidth on an as needed basis to cus-

tomers.

The Plug and Play application will also work in an HTTP/SNMP

managed system using the by deploying a SNMP Management Module

agent card with mDSL Rack Cards installed in Black Box’s 2U Access

Rack system. In this application, the system administrator can config-

ure the entire rack through the Network Management Station (NMS)

before the stand alone (CP) units are installed. For more information

on the HTTP/SNMP management, please refer to the SNMP

Management Module Operations Manual.

Compact mDSL Modem

Configuring the Hardware DIP Switches

The Compact mDSL Modem has two sets of eight DIP switches,

which allow configuration for a wide variety of applications. This sec-

tion describes switch locations and explains all settings.

The 16 external switches are grouped into two eight-switch sets,

and are externally accessible from the underside of the Compact

mDSL Modem, as shown in Figure 4, below.

The two sets of DIP switches on the underside of the Compact

mDSL Modem will be referred to in this manual as S2 and S3. As

Figure 5 shows, the orientation of all DIP switches is the same with

respect to “ON” and “OFF” positions.

OFF

FRONT

REAR

Figure 4.Underside of Compact mDSL Modem, showing location of DIP switches

OFF

Figure 5. Close Up of Configuration Switches (all sets are identical in appearance)

Compact mDSL Modem

1 2 3 4 5 6 7 8 9 10 11 12 13

Keine Kommentare

Black Box MDS920C-10BT Spezifikationen Seite 5