Black Box MT1000A-13-R3 Spezifikationen PDF herunterladen (Seite 18)

Chapter 2 Installation and Setup MT1000A Installation and Operation Manual

2-2 Package Contents

Fiber Optic Link Connections

Each fiber optic link interface is terminated in two ST, SC, or FC-PC connectors, in

accordance with order. The maximum allowable attenuation depends on the

interface option ordered (refer to Table 1-1).

When working with the WDM option, only one fiber optic cable per link should

be connected. The two types – SF1 and SF2 – must work opposite each other; SF1

cannot work opposite SF1, and SF2 cannot work opposite SF2.

Front and Rear Panel Clearance

Allow at least 90 cm (36 inches) of frontal clearance for operator access. Allow at

least 10 cm (4 inches) clearance at the rear of the unit for interface cable

connections.

When planning the routing of fiber optic cables, avoid sharp bends.

Unit Clearance

Allow 1U clearance above MT1000A-E1 for proper ventilation.

Ambient Requirements

The ambient operating temperature of the MT1000A is 0° to 50°C (32° to 122°F),

at a relative humidity of up to 90%, non-condensing.

2.3 Equipment Needed

The equipment needed to install the MT1000A is:

• ST, SC or FC/PC fiber optic interface link connector cables

• RJ-45 T1 connector cables (for tributary interface)

• Phillips screwdriver (for installation in 19 inch rack).

2.4 Package Contents

The MT1000A package contains the following:

• MT1000A multiplexer

• CBL-DB9M/DB9F cable

• Two power supply cables

• AC/DC Adaptor (AD) plug

• MT1000A Installation and Operation manual

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 77 78

Keine Kommentare

Black Box MT1000A-13-R3 Spezifikationen Seite 18